CR Clarke Hot Wire Cutter/Sculptor 280H badge_SALE

CR Clarke Hot Wire Cutter/Sculptor 280H badge_SALEA thin piece of resistance wire has a low voltage passed across it. This heats the wire. A piece of expanded thermoplastic material (normally polystyrene) is pushed onto the wire. The heat locally melts the material, collapsing the air pockets that it contains and allowing the wire to pass through. In this way the expanded material can be cut cleanly. The Hot Wire Sculptor 280H incorporates: 280mm(11in) cutting length 635mm(25in) throat depth

Kitronik Access:Bit Contents

1 x Recharge Docking Station V2

Fixed Scan with Turntable

There are a range of mounting holes at either end of the rack including a 3mm hole

To print with this material in the UP software

1 x Small Prototype Breadboard

Perfect for classrooms where space is precious

1x Teacher's Guide

Not only that

If you undo the third servo hack and return the board to its original state

well this block starts serial transfer of data between the micro:bit and the CO2 sensor

2x Red LED