Holley EFI - Hall Effect Crankshaft Signal Sensor

Holley EFI - Hall Effect Crankshaft Signal SensorDesigned as a drop in sensor replacement for flying magnet crank trigger setups using a 16 threaded magnetic sensor. This sensor is a hall effect sensor, meaning it outputs a square wave signal, which is ideal for use with most electronic fuel injection systems. This sensor is to only be used with a trigger wheel with flying magnets. It does not detect a ferrous steel target. The sensor can operate from 5 20 volts. It is recommended to feed the sensor

Maximum dyno gains of 14 hp and 16 lb-ft

5 in ID - 8 in Length - 600 lb/in Spring Rate - Steel - Black Powder Coat - Each

Brake Pads - ProACT - Rear - Lexus ES 2002-06 / Toyota Camry 2002-06 - Set of 4

Electrical Contact Cleaner - 13 oz Aerosol - Each

but pump life will be diminished if used with 100% ethanol fuels

Brake Pads - Euro - Rear - BMW 3-Series 1995-2006 - Set of 4

810 in Head - 11/32 in Valve Stem - Stainless - Edelbrock Performer RPM 440 - Mopar B / RB-Series - Each

This bolt-on emissions legal system fits trucks with either a V8 or V10 engine and features all aluminized steel mandrel-bent construction

with a moderate interior tone and all the performance benefits you would expect from Flowmaster®

320 in OD - Set of 16

5 in Top - 7

Spark Plug Wire Set - Super Stock - Spiral Core - 8 mm - Blue - Factory Style Boots / Terminals - Ford V8 - Kit