Eye nut Hot Dip Galvanized 1-8 * 2-1/8 partially_threaded

Eye nut Hot Dip Galvanized 1-8 * 2-1/8 partially_threadedCreate your own lifting eye by adding an eye nut to a stud or bolt. Galvanized steel eye nuts have a hot dipped finish for more corrosion resistance than zinc plated steel. The nuts have a thread of 1 8 and a lenght of 2 1 8. Note: Working Load Limit applies to the eye nut only. The stud or bolt you use will affect the overall Working Load Limit. Eye nuts are for vertical lifting only. Warning: Never use to lift people or items over people. Nuts have

Polyester slings have minimal stretch to provide more control over the load and resist most acids

This hexagonal bolt has a length of 10 with a threading of 1-1/2-6 [Partially Threaded]

The rod has a length of 36" and a thread of 1-8

The 316 Stainless Steel increases its strength against the pressure and has a tensile strength and hardness of 75

The rod has a thread of 3/8-16 and a length of 36"

000 psi | Rockwell B79

The bolts have a thread of 1-8 and a length of 6

provides high resistance to corrosion in dry and wet environments

5 | SAE J429 and comply with dimensional standards

lead screws and nuts have broad

Eye nuts are for vertical lifting only

a width of 2 and a length of 2