Stage6 Rear facing intake manifold bearings

Stage6 Rear facing intake manifold bearingsCNC milled intake manifold spacer with very sturdy high quality carburetor installation stud made of FKM (Viton). In combination with the Stage6 subframe, the spacer lets you directly install Stage6 R T VHST and flat slide carburetors facing the rear wheel without the carb being at a too low angle that would result in overflow. Special attention has been paid to the design of the intake tract. The canal hasnt been simply drilled through, but runs in a

Giantco G-10 50 AIR 2T '10->

Stainless Steel Brake Lines

Malaguti Firefox F15-50 AC (04 -)

491 50cc LC (before 2002) - Minarelli horiz

Polini X5 kickstart gear and return spring

Hussar 50cc AC (after 2003) - Min horiz

The inside of the rollers sliding surfaces has been submitted to a glazing treatment to improve rollers sliding

·        Yamaha Bw's Original R12 50 AIR 2T '03

Polly 50cc 2-stroke

This is a race pipe and does not work with the center stand

Ice 50cc AC

·        Malaguti F15 Firefox 50 H2O '96-'98