QA1 A Series Endura Rod End - Male/Left Hand - .375in Bore x 3/8-24 - Red Aluminum Legacy XT / GT

QA1 A Series Endura Rod End - Male/Left Hand - .375in Bore x 3/8-24 - Red Aluminum Legacy XT / GTAM Aluminum Series rod ends from QA1 are male rod ends that are designed specifically to save weight on performance applications. They feature a Nylon PTFE injection molded race and are completely self sealing and self lubricating, keeping dirt and debris out. The AM Series rod ends are over 10% lighter than traditional three piece aluminum rod ends and are the most wear resistant aluminum design available. BALL, 52100 Bearing Steel, Heat Treated,

Completing this system is a Trac Bar relocation bracket

Enclosed Intake Completely Seals Out Hot Engine Bay Air

CNC machined fuel rail for the Honda S2000

Our rails are made from 6061 Billet Aluminum with a 5/8" ID for maximum fuel flow and threaded for -8 O-Ring boss fittings (not included)

but only when the base "static" fuel pressure is set within these ranges and the vacuum/boost reference line is connected

Stock hot side tube is dented at the factory

Hawk HT14's are not designed to perform at the low temperatures that are normally experienced in ANY streetcar

increase horsepower

25 Lug Nut Set 16 Lug 4 Lock Set - Blue

GSC P-D Ford Mustang 5

SPAL 844 CFM 11in Low Profile Fan - Pull/Curved (VA09-AP12/C-54A)

Two plastic trim removal tools are included to assist with installation