6'5" Jive Lifter surfboards

6'5" Jive Lifter surfboards6'5" x 20 3 4" x 2 3 4" Jacob Ells is a Santa Barbara based shaper who is always looking to push the boundaries of alternative boards. The Lifter is one of Jives newest models and one of Jacob's most intriguing. The outline's widepoint is set further back, with a winged thumb tail, and pulls in quickly at the nose. The rocker profile is very flat and the rails are very bladey. The bottom contour starts with a slight single in the nose that tuns into a

Our shop is conveniently located for Alex Knost

7'0" x 22 3/4" 17 3/4" Nose 15 3/4" Tail x 3" (Fin included)

The bottom contour starts with a slight roll in the nose that fades into a deep bonzer concave that runs between the fins and ends with vee out the tail

The the length up front still allows you to log out and get some expedited tip time in while the pulled in tail allows you to smoothly dig into power turns giving you a taste of the benefits on both ends of the volume spectrum

bowls-esque outline with the wide point pushed very far back

SupaKitch worked with gold paint under the glass while Son of Cobra glassed over the artwork with a white opaque resin

Whether you are sealing the sensitivity of a compromised barrier or simply seeking that elusive 'my skin

The rails are soft with a harder edge in the tail

9'2" x 22 7/8 x 2 11/16"

The rails are boxy

when combined with the weight and low rocker profile

this board flies down the line and allows for smooth transitions from one section to the next