60MM X 5MM Boss

60MM X 5MM BossThis steel bucket pin shim is for a pin with an outer diameter of 60 mm. It is 5 mm thick with an OD of 120 mm. Perfect for when you have space between your bucket ears and your machines hook up. Too much of a gap will cause your Bucket to wobble or chatter around on your machine causing wear and tear on your pins and bushings. A bucket pin shim will work just fine if it is a little larger than the Outer Diameter of your pin but not if it is smaller

Without this protection your base edge will scallop out over time

END BIT LH

Asphalt and concrete

This is a genuine ESCO Ultralok replacement lock for all u45 series teeth

This is a weld on

This is a cat j300 series style single tiger bucket tooth with industry standard part number of t1u3302L also 168-1300

11" BRUNNER AND LAY

Use v39 series teeth with this pin

This is a V33pn Esco style Super V pin

This steel bucket pin shim is for a pin with an outer diameter of 70 mm

This tooth is considered a penetrator style and is found mostly on backhoes

It will work for all 19mm shaft milling bits part # JMXA-FP19