SOS Leak SensorThe SOS Leak Sensor can detect water leaking into an improperly sealed watertight Enclosure, before any major damage can occur. When a leak is detected, the signal is pulled high to VCC and bright red LED shines, making it easy to integrate with an Arduino, Raspberry Pi, Pixhawk, and many other 3. 3v or 5v devices. The Ardsub firmware supports the SOS Leak Sensor on the Pixhawk by default. Contents 1 x SOS Leak Sensor Probe Host Board 2 x 6 Probe 2 x
In addition to the thruster
The M200 Motor and Weedless Propeller make an ideal propulsion system for small unmanned surface vessels (USVs)
2 x T200 Thruster BlueROV2 Spare (CW and CCW)
One 3-pin connector handles the high-voltage power and ground connection while an 8-pin connector handles the signal connections
1 x RC Charger
the BlueBoat will eventually be compatible with other types of communication for longer range
The Fifish waterproof Backpack is ideal for outdoor use
The High-Power Tether Cable is designed to be used with the Outland Technology Power Supply System
This Backfill Adapter is for use with the Pressure Relief Valve and the Vacuum Plug to fill an enclosure with an inert gas or to pull an enclosure to vacuum while maintaining a seal
5-4mm or 6-8mm)
Two separate connectors are used to handle the required voltage ratings and to separate high voltage and low voltage signals
this propeller is optimized for efficient thrust
