2 Pack Trailer Brake Cable Back Plate Retaining Shell Cover Knott Brake Systems 1/4" Drive Socket Sets

2 Pack Trailer Brake Cable Back Plate Retaining Shell Cover Knott Brake Systems 1/4" Drive Socket SetsA pack of two trailer brake cable back plates half shells Manufactured from chrome vanadium steel for strength and durability Zinc plated for rust and corrosion resistance The cable shroud cover fits into the rear back plate and then the cable goes over it to keep it rigid in place Suitable for all the Knott brake systems where the end of the brake cable is 26mm You will need two of these for each cable as it goes into the back plate (one is normally

This listing is for a 34mm Jockey wheel and clamp on mount

•1 x 5m Rear Light Connection Cable

Add a bit of history to your fish tank with this beautifully designed and stunning ornament

• Total length of the thread under the hex 10mm

Length: 28

Hex head on the bleedscrew for easy installation or removal by a spanner or a deep socket

24oz hammer

- GREEN - The water content in the brake fluid is less than 1

Applicable : VW

6 sided / single hex tubular box spanners

• 90 degree air angled head air sander

Very useful for aiding in tacking frames together before fully welding