PRESSURE BLEEDER HEAD ASSEMBLY FOR M54 AND M809 SERIES- PB1 M939

PRESSURE BLEEDER HEAD ASSEMBLY FOR M54 AND M809 SERIES- PB1 M939OUR PRESSURE BLEEDER ASSEMBLY w OPTIONAL GAUGE IS MADE OF HIGH QUALITY BRASS FITTINGS AND COMES ASSEMBLED WITH TEFLON TAPE IN THE JOINTS AS PICTURED. THE INCLUDED GAUGE FEATURE WILL LET YOU KNOW YOUR CURRENT PRESSURE SO YOU DONT CLIMB UNDER THE TRUCK AND NOT REALIZE YOUR TOO LOW ON PRESSURE TO FINISH THE BLEEDER YOU ARE WORKING ON. THIS IS ASSEMBLY THREADS IN TO THE MASTER CYLINDER CAP ONCE THE VENT LINE BRASS FITTING IS REMOVED. ONCE IN PLACE, THE

INNER WHEEL BEARING AND RACE FOR M35A1 AND M35A2 MODELS

PART # 7024132

USUALLY LOCATED ON THE INJECTION PUMP

YOU SHOULD INSPECT THESE FREQUENTLY AND REPLACE AS NECESSARY

TWO REPLACEMENT LENSES FOR MILITARY TAIL LIGHTS

LIMITED SUPPLY OF ODD LENGTHS AVAILABLE

LEFT SIDE RADIATOR SHROUD SHIELD FOR M35A2

THIS PART IF FOR THE LEFT OR RIGHT SIDE OF THE WINDSHIELD AND FITS A WIDE VARIETY OF MILITARY VEHICLES

# 7064466 NSN 5340003216375

AND FITS THE TRANSFER CASE INPUT AND OUTPUT ON ALL 5 TONS

1/4" RETURN FUEL LINE ALSO AVAILABLE IF NEEDED

ONE NEW ENGINE BLOCK HEATER SET FOR MILITARY M35A3 MODELS WITH THE CATERPILLAR ENGINE